ClearOne Connect AVB - Manual (Page 11)

QUICK-START GUIDE
9
RX and TX Bundle Numbers
When a receiver on one interface is assigned the same bundle number
as that of a transmitter on another interface, the CobraNet protocol
automatically establishes a connection for transmitting audio data
between the interfaces.
ClearOne CobraNet is a single-bundle, eight-channel device with a
fixed 48 kHz sample rate. The eight channels of audio correspond to
E-bus assignments S through Z. Any audio placed on these busses will
be transmitted in the CobraNet bundle. Any audio received from the
CobraNet bundle can be taken off the S to Z bus on any CONVERGE Pro
Unit.
Latency
The buffering and transmission of audio data typically incurs a delay of
256 samples or 5 1/3 milliseconds called Bundle Latency. This delay can
be reduced by sending smaller packets more often but comes at the cost
of higher processing demands and greater network demands
Channel Assignment
Complete the audio channel assignments in the Matrix in CONVERGE
Console for the channels present in the network bridge. When a CobraNet
is added to the site any audio on the S Bus will automatically be placed on
the CobraNet transmit bundle on Audio channel 1.