ClearOne Beamforming Microphone Array Quick Star - Manual (Page 11)

QUICK-START GUIDE
9
USING THE BEAMFORMING MICROPHONE ARRAY
The Beamforming Microphone Array must be added to the site using
the CONVERGE Console 4.X software. This software also provides the
capability of configuring the pickup pattern and other characteristics
available in Configuration mode. Refer to the online help available with the
CONVERGE Pro software.
V
olume
& m
ute
These controls are available through the controller configured for your
CONVERGE Pro site.
m
icrophone
A
rrAy
leD i
nDicAtors
The illuminated microphone indicators at the ends of the Beamforming
Microphone Array show blue/red when the microphone array is active/
muted. You can set the indicators to remain off by using CONVERGE
Console to change Unit Properties for the Beamforming Microphone
Array. See the help file for more details.
conVerGe c
onsole AnD
c
onsole
m
AnAGer
The CONVERGE Console 4.0 installer only comes with CONVERGE
Console 4.0. CONVERGE Console versions 3, 2 and 1 are not part of the
install like that of CONVERGE Console Installer 3.0.
A new version CONVERGE Manager comes with the CONVERGE
Console 4.0 installer. If CONVERGE Console 3 is installed the,
CONVERGE Manager will show all 4 versions of CONVERGE Console,
1.0, 2.0, 3.0, and 4.0. If CONVERGE Console 3 is not installed, then the
CONVERGE Manager with only show CONVERGE Console 4.