ClearOne Beamforming Microphone Array Quick Star - Manual (Page 4)

BEAMFORMING MICROPHONE ARRAY
2
QUICK-START OVERVIEW
Installing and using the Beamforming Microphone Array in your
CONVERGE Pro site is subject to the following rules:
1. The Beamforming Microphone Array can only be used with
CONVERGE Pro systems operating at version 4.X or greater,
and requires that the firmware on the CONVERGE Pro and the
Beamforming Microphone Array both be updated.
2. You must have a CONVERGE Pro 840T, 880, 880T and/or 880TA
in the site. (The Beamforming Microphone Array will not work with
standalone TH20, VH20, 8i, 1212, or 1212A units.)
3. You can have up to 3 Beamforming Microphone Arrays per valid
CONVERGE Pro unit up to a total of 16 Beamforming Microphone
Arrays per site. More valid CONVERGE Pro units may be added to
increase the number of Beamforming Microphone Arrays.
Quick Start Procedures
These steps must be done in the following order to use the Beamforming
Microphone Array in your CONVERGE Pro Site:
1. Update the CONVERGE Pro firmware to version 4.X using
CONVERGE Console.
2. Connect the Beamforming Microphone Array to the updated
CONVERGE Pro via the E-bus.