Monarch Instrument Nova-Strobe bbx - Manual (Page 10)

5.0 LAMP AND FUSE REPLACEMENT
5.1 Lamp Replacement
WARNING: Before attempting to remove the lamp, make
sure the stroboscope is turned off and any
mains cord is removed from the AC outlet. Allow
the lamp to cool waiting at least 5 minutes.
The stroboscope is designed to discharge the internal high voltages
within 30 seconds. However, caution should be exercised when replacing
the lamp.
The lamp can be replaced by using just a pocket screwdriver. It is not
necessary to remove any screws to replace the lamp.
To change the lamp:
1.
Push apart the two tabs on the side of the reflector housing and
remove the lens using a small screwdriver to help pry one tab and
lift the lens. Take care not to pry the tab any more than is necessary
to free the lens. The reflector is held in place by the front lens and
will come loose, but it is not necessary to remove the reflector.
2. Hold the lamp with a cloth between your forefinger and thumb
and rock it back and forth gently while pulling out. Do not attempt
to rotate the lamp. The lamp is socketed and will come out easily
when pulled straight out.
WARNING: Do NOT touch the new lamp with bare fingers.
3. The lamps are polarized and must be put into the socket matching
polarity. Using a lint free cloth, match up the red dot on the
plug with the red dot on the socket and gently rock the lamp
E-6 S-7
3. Las lámparas son polarizadas y deben ser puestas en el enchufe
que empareja la polaridad. Utilizar una hilas libertan tela, el
igual arriba el punto rojo en el tapón con el punto rojo en el
enchufe y mecen suavemente la lámpara al empujar en lugar (Vea
la Figura 4). Cerciórese lámpara está en recto y centrado en el
hoyo de reflector.
El CUIDADO: No permita el reflector para contactar la
lámpara.
4. Vuelva a instalar el reflector y entonces posicione el lente anterior
en el igualar del lugar los cortes en el lente con las dos pequeñas
etiquetas en la envoltura para prevenir la rotación de lente (ve la
figura 4). Empuje las etiquetas en el borde anterior exterior y
apriete el lente en el lugar.
Figura 4 Reemplazo de Lámpara
Los Puntos
Rojos
Los Cortes