Great Plains 3N-30P Assembly Instructions - Manual (Page 6)

196-264m 4/8/2004
Great Plains Mfg., Inc.
Monitor Systems Option 6
19257
Refer to Figure 5
1. Mount one end of the harness to the frame as
shown in figure 5. Route the wire extension using
the same path as the opener lift hoses allowing the
same slack at the drill toolbar pivots as the other
hoses. Use the cable ties provided to fasten the har-
ness to the frame.
2. Mount the center module to the frame. Route the
wire extension through the tongue tube as shown in
figure 2.
3. Connect the wire extensions to the openers starting
at the left side of the drill in numerical order. Wire ex-
tension number 1 with first opener on the left. Con-
tinue in the same manner until all wire extensions
are connected. Fasten the wires down with cable
ties.
4. Attach sensor lead (380) from the center module to
the console in your tractor.
5. Refer to page 7 for a detailed listing of parts and
schematics for this particular monitor system.
6. For console assembly, speed sensor and other
schematics illustrations refer to the DJ manual
found in the monitor system package.
7. Refer to page 8 for speed sensor instructions if sen-
sor is being used
Assembly Instructions for 833-234C Harness for 15 inch Row Spacing,
Twin Row only Machines and 833-169C Console
.
Figure 5