Cadillac 2008 CTS - Manual (Page 152)

If your vehicle has the StabiliTrak ® system and begins
to limit wheel spin while you are using cruise control, the
cruise control will automatically disengage. See
StabiliTrak
® System on page 4-8. When road conditions
allow you to safely use it again, the cruise control
can be turned back on.
The cruise control buttons
are located on the left side
of the steering wheel.
I
(On/Off): Press button to activate and turn off the
system. The indicator light on the button turns on
when cruise control is on.
+ RES (Resume/Accelerate): Press this button to
make the vehicle accelerate or resume to a previously
set speed.
SET
−
(Set/Coast): Press this button to set the speed
or make the vehicle decelerate.
[
(Cancel): Press this button to cancel cruise control
without erasing the set speed from memory.
Setting Cruise Control
Cruise control will not work if the parking brake is set, or
if the master cylinder brake fluid level is low.
The cruise control light on the instrument panel cluster
comes on after the cruise control has been set to
the desired speed.
{ CAUTION:
If you leave your cruise control on when you
are not using cruise, you might hit a button
and go into cruise when you do not want to.
You could be startled and even lose control.
Keep the cruise control switch off until you
want to use cruise control.
1. Press the cruise control On/Off button.
2. Get up to the desired speed.
3. Press the SET
−
button located on the steering
wheel and release it.
4. Take your foot off the accelerator.
3-14