Chicago Electric HARBOR FREIGHT TOOLS 98753 - Manual (Page 7)

SKU 98753 For technical questions, please call 1-800-444-3353. Page 7
SpeciFicatiOnS
Maximum Amperage 55 A
Material Range
18 to 22 Gauge Sheet
Metal
Welding Rods
1/16” Diameter, 6013 &
6014 (not included)
unpacKing
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
Operating inStructiOnS
read the entire impOrtant
SaFetY inFOrmatiOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
tool Set up
tO preVent
SeriOuS injurY
FrOm accidental
OperatiOn:
turn the power Switch of the
arc welder to its “OFF”
position and unplug the tool
from its electrical outlet
before performing any
inspection, maintenance, or
cleaning procedures.
work piece and work area Set up
Designate a work area that is clean 1.
and well­lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
Route the power cord along a safe
2.
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage.
The power cord must reach the work
area with enough extra length to al­
low free movement while working.
Secure loose work pieces using a
3.
vise or clamps (not included) to pre­
vent movement while working.
There must not be hazardous ob­
4.
jects, such as utility lines or foreign
objects, nearby that will present a
hazard while working.
general Operating instructions
tO preVent
death Or
SeriOuS injurY:
do not touch any metal part of
the Stitch welder when it is in
use.
Read the manual for the ARC (stick) 1.
welder being used with the Stitch
Welder.
If welding on a vehicle; disconnect
2.
the negative terminal of the vehicle’s
battery.
Clean the work area thoroughly be­
3.
fore beginning operation. Remove
all grease, paint, or oil from the work­
piece.
Wear protective gear whenever weld­
4.
ing.
Loosen the Rod Holder (15) and
5.
insert a 1/16” diameter 6013 or 6014