Amico TTS Vertical Flat Wall - Manual (Page 10)

10 Amico Beds
Installation
Sapphire Series Flatwall
Rear Connection
CAUTION: Ensure that all power switches are in the OFF position prior to commencing the installation of the
Amico Teaching Solution. DO NOT plug in any electrical cords until instructed to do so.
Connect the other end of the hose to the
Compressed Air DISS Outlet. Using a 7/8”
wrench should help ensure that the hose
is fastened securely to the outlet.
For the Sapphire Series Teaching Solution,
the compressed air outlet shall be located
on the front or rear of the unit, while the
Flatwall Teaching Solution shall have the
compressed air outlet located on the side
of the unit.
Attach the compressor hose to the DISS
connection on the Air Compressor.
Use a 7/8” wrench to ensure that the hose is
securely fastened onto the DISS connection.
This shall ensure that the compressor shall
operate effectively.
1.
2.