Aphex A PRE 500 - Manual (Page 3)

Page 4 Page 5
1. Turn off and unplug your 500 series rack frame. Inspect the
card slot you intend you use to make sure that it is clean and
free of any debris.
2. Before removing your A PRE 500 from its box, discharge any
static electricity buildup you may have by touching your 500
series rack.
3. Pull your A PRE 500 module out of its box and carefully slide
it into place in the designated opening. Sight down the back of
the module (use a flashlight if necessary) and ensure the card
edge connector is aligned to seat into the card slot of the frame.
4. Firmly and evenly push the A PRE 500 module into place until
it is positively seated in the card slot.
5. Use the 2 thumb screws in the module to mount the A PRE
500 front panel to the 500 series rack. These screws have a
pretty tight fit; please be careful not to cross thread.
6. Plug your 500 series rack back into the AC source and power
up your rack. Your A PRE 500 will automatically power up with
your 500 series rack.
TABLE OF CONTENTS
1.0 INSTALLATION 5
2.0 INTRODUCTION 6
3.0 CONTROLS AND INDICATORS
3.1 Trim Control 6
3.2 Input Meter 6
3.3 Output Level Switch 6
3.4 -26dB Pad 7
3.5 Phase 7
3.6 75Hz High Pass Filter 7
3.7 48V Phantom Power 7
3.8 Instrument Input 8
4.0 WARRANTY AND SERVICE
4.1 Limited Warranty 9
4.2 Service Information 10
5.0 CONTACT INFO 11
1.0 INSTALLING THE A PRE 500 IN A 500 SERIES RACK