Mounting procedure – B&G Network Pilot (ACP) User Manual
Page 15
Advertising
1 - 14
MOUNTING PROCEDURE
•
To ensure correct steering sense the unit is marked with two indents,
the unit must be installed with these forward.
•
The unit requires at least 65mm/2.5" clearance behind the selected
mounting position.
•
Use a 40mm (1 9/16th") hole cutter for the joystick body.
•
Ensure the gasket is fitted under the joystick body flange.
•
Secure in place with self-tapping screws.
•
Route the cable to ACP unit. Connect as per instruction in Section 4
of this handbook.
For details on how to install the controller button refer to the MOB
section.
Advertising