Baseline Systems BaseStation 3200 in Pedestal - Manual (Page 8)

Installation and User Guide for Baseline Cell Modems in Pedestal Enclosures
Step 3 – Attach the Antenna Riser to the Pedestal
1. Align the holes at the bottom of the antenna riser
with the holes in the gasket at the mounting
location on the outside left wall of the pedestal.
2. Feed the free end of the antenna cable through
the small hole that you made in the gasket and
into the inside of the pedestal.
3. Working from the outside of the pedestal, insert
the bolts that you removed earlier into the four
holes.
4. Working from the inside of the pedestal, thread
the nuts that you removed earlier onto the four
bolts. Tighten the nuts snugly.
Step 4 – Install the 3G Cell Modem Hardware
IMPORTANT! The BL-CM3G cell modem hardware is compatible with all BaseStation 1000
controllers in X cabinet and pedestal (P) enclosures. BaseStation 3200 controllers in X and P
enclosures shipped after April 16, 2014 are also compatible. Earlier BaseStation 3200 models
require different 3G cell modem components.
1. We recommend that you back up your current configuration before starting this process in
case you need to restore your system.
 Refer to Backing Up the Controller Programming in the BaseStation 1000 User Manual.
 Refer to Backing Up Your System in the BaseStation 3200 User Manual.
2. Halt all watering while you install the cell modem hardware.
 BaseStation 1000: Press the OFF button.
 BaseStation 3200: Turn the dial to the OFF position.
3. Open and remove the front door on the lower part of the pedestal.
Page 4