Baseline Systems BaseStation 3200 in Pedestal - Manual (Page 9)

Installation and User Guide for Baseline Cell Modems in Pedestal Enclosures
4. Find the orange power connector on the wires coming from the transformer. Gently pull the
connector away from the board to disconnect the power.
Note: The illustration shows the black plastic dust cover removed from the controller board;
however, you can install the cell modem without removing the dust cover.
5. Remove the cell modem hardware from its packaging.
6. Plug the power cord into the cell modem module.
7. Plug the Ethernet cable into the Ethernet jack on the cell modem module.
8. Attach the male SMA connector (small end) on the antenna cable to the connector on the cell
modem module labeled WWAN Main.
9. With the antenna and Ethernet cables pointing up and the power cord pointing down, align
the two mounting holes on the right side of the cell modem module with the standoffs on the
back wall of the pedestal. Use the screws provided to secure the board to the enclosure.
10. Plug the 5-pin connector from the cell modem power cord into the lower 5-pin terminal block
(comm port 3) on right end of the controller board.
Note: If another connector is attached to the lower 5-pin terminal block, disconnect it, and
then reconnect it to the top 5-pin terminal block.
Page 5