Baseline Systems BaseStation 3200 in Pedestal - Manual (Page 2)

BL-3200WF-P Wi-Fi Module for Pedestal
Installation Guide
1-866-294-5847
Rev 10.9.2014
www.baselinesystems.com
Prepare the Mounting Location for the
Antenna Riser
1. Open and remove the front door on the lower
part of the pedestal.
2. On the inside left wall of the pedestal, remove
the nuts from the bolts that secure the cover on
the outside wall. Set the nuts aside to be
replaced in a later step.
3. Remove the bolts that are holding the cover on
the outside wall. Set the bolts aside to be
replaced in a later step.
4. Remove the cover from the outside wall, making
sure that the gasket stays in place.
5. On the inside left wall of the pedestal, find the
opening that is covered by the gasket. Use a
sharp hobby knife to poke a small hole to mark
the center of the opening.
6. Remove the gasket and place it on a solid
surface. Use the hobby knife to cut a small X that
intersects the small hole that you made. Make
each cut approximately ½ inch long.
Note: This opening is used to route the
antenna cable inside the pedestal in order to
connect it to the cell modem. Make the X
large enough to pass the cable through, but
small enough to maintain the seal.
7. Position the gasket on the outside wall of the
pedestal so the bolt holes are aligned and the
small X is aligned with the opening for the
antenna cable.
Note: You’ll need to hold the gasket in place
while you attach the antenna riser in the next
step. For this part of the procedure, it’s nice
to have a helper.
Continued 
Page 2