Baseline Systems X-Series Pedestal - Manual (Page 2)

Baseline X Pedestal
Installation Guide
1-866-294-5847
Rev 3.8.2013
www.baselinesystems.com
Mount the Pedestal Base to the Concrete Pad
1. Build a form for the concrete pad.
2. Pour the concrete, and finish the top with a slope for drainage.
3. Push the heads of 4 stainless steel anchor bolts into the wet concrete in a pattern that matches the
mounting holes in the pedestal base. The concrete should form a smooth, flat surface for the base
to bolt onto.
4. After the concrete completely dries, position the mounting holes on the pedestal base onto the
stainless steel bolts, and then use the washers and nuts to secure the pedestal base to the concrete
pad.
Mount the Pedestal to the Base
1. Position the pedestal over the base and lower it into place, making sure
that the holes for the screws are aligned.
2. Insert the 6 screws and securely tighten the nuts.
Attach the Controller Mounting Bracket to the Pedestal
1. Align the tabs on the controller mounting bracket with the slots in the top
of the pedestal, and then slide the mounting bracket into place.
2. Insert the 5 screws and securely tighten the nuts.
3. Thread the small screw into the hole at the top of the mounting bracket
and tighten it part way.
Mount the Controller to the Pedestal
1. Align the mounting plate on the outer back of the X cabinet with the
small screw at the top of the controller mounting bracket on the
pedestal, and then slide the cabinet into place.
Thread the small
screw into this hole
and ghten part way
Pedestal Base
Holes for mounting bolts
2. Make sure that the screw on the mounting bracket comes through the hole in the back of the
cabinet.
3. When all pieces are aligned correctly, attach a nut to the screw inside the cabinet.
4. Connect the electrical wiring and the irrigation wiring.
5. Replace the door on the front of the pedestal.
in the concrete