Baseline Systems BL-Commander User Manual
Page 11
Reprogramming the Transmitter
You must first wait at least 10 seconds after any key has been pressed before reprogramming. The
following example reprograms the Transmitter to the factory defaults. YOU DO NOT NEED TO
CHANGE ANYTHING TO MAKE YOUR UNITS OPERATE!
Step 1:
Step 2:
Step 3:
Step 1 gives you access to the Transmitter’s memory.
Step 2 sets the Group Code to “0001”.
Step 3 sets the Receiver Number to “1”.
The units come from the factory set to communicate with each other on Group Code #1, and
Receiver #1. YOU DO NOT NEED TO CHANGE ANYTHING TO MAKE YOUR UNITS OPERATE!
You only need to reprogram your Transmitter if you change the dipswitch settings on the Receiver. If
you choose to do so, you will need to follow the steps above, making sure you change the Group
Code and Receiver Number (steps 2 and 3) to match that of the Receivers, as explained on the next
page.
If the battery is removed for more that 2 minutes (or if it has died) you only have to reprogram the
Transmitter if you have previously changed your Group Code or Receiver Number settings from the
factory defaults. The Transmitter will remember the Group Code and Receiver Number for
approximately
2
minutes
with
battery
removed
for
replacement.
800-275-8558
www.irrigationremotes.com