BlueAnt V1x Voice Controlled Headset - Manual (Page 12)

BlueAnt
12
VOICE CONTROL – Available Commands
The following is a comprehensive list of the commands available in the V1.
At any time you can use the “What can I say?” command to hear the available commands
Pair Me – Puts your V1 into pairing mode ready to connect with your phone. Follow the Prompts.
Teach Me - This menu helps you to understand and use the V1
Try it Now – Takes you through a program which lets you practice the voice commands.
Speed Dial Set Up – Assistance in how to set up the Speed list in your phone
Tips and Tricks – Some helpful information to get the most out of the kit
What Can I Say? – Gives you a list of all the available commands
Am I Connected? – Checks to see if there is a phone connected. If not it will attempt to connect to your phone.
Check Battery – Tells you the status of your battery charge level
Settings Menu – Puts you into the Settings menu
‘Say a command’ Prompt - Enables or Disables the ‘Say a Command” prompt. With it disabled, you will hear a beep instead.
Incoming Call Function – Disable the Incoming call ID prompt and Voice Answer functions.
Turn Off Voice Control – Turns OFF the Voice Control. To re-enable, Hold Vol+ and Vol – for 6 seconds
Sensitivity Level – Choose from High Medium and Low. High will reject more, low will reject less.
LED Light – Turns the LED Lights OFF
Reset the V1 – Deletes all pairing information resets the Voice Interface and reboots the headset back into pairing mode