Cooper Instruments & Systems Model 7i Professional Force/Torque Indicator User Manual
Page 7
Model 7i Digital Force / Torque Indicator
User’s Guide
6
on the printed circuit boards.
3.3 Mounting to a plate
The 7i can be mounted to a plate with four thumb screws fastened into the appropriate holes in the rear
half of the housing. Refer to the Dimensions section for detailed hole information and locations.
3.4 Installing the USB driver
If communicating via USB, install the USB driver provided on the Resource CD. Installation instructions
may also be found on the CD or may be downloaded from
www.mark-10.com
.
Caution!
Install the USB driver before physically connecting the indicator to a PC with the USB cable.
Further instructions for configuring and using the indicator’s outputs are provided in the Communications
and Outputs section.
Sensor connector
oriented up
Sensor connector
oriented down