Cooper Instruments & Systems DFR 1250 Two Channel Paperless Recorder - Manual (Page 16)

TSFM 500 DC 14 32-1101 REV 2 710
6.2 Menu Navigation
At power-up, the display will show the operation screen for whichever mode was used last. The display will appear as
one of the following:
Basic & Auto Return Modes:
Cycling Mode:
PC Mode:
Appears the same as in Basic and Auto Return modes.
Pressing menu will enter Test Parameter Setup. If a password has been programmed, the display will prompt the
following:
The password is a four digit number. The first digit in the password will be flashing, signifying that it is active and can be
incremented by pressing +. To advance to the next digit, press –>. Change subsequent digits in the same fashion. Once
the complete password has been entered, press ENTR. If correct, the display will enter Test Parameter Setup Mode. If
the password is incorrect, the words INCORRECT PASSWORD will flash, and the display will revert to Operating Mode.
6.3 Basic Mode
The test stand moves in the direction indicated by the UP and DOWN buttons. When the test stand is in motion, an LED
indicator on the button pushed will be illuminated. The KEYS setting controls how test stand movement responds to the
push of the UP and DOWN buttons. The three settings are:
1. Maintained (default)
The test stand will move continuously once the button has been pressed. Subsequently pressing STOP during a
test will stop motion.
2. Momentary
The test stand will move only if the button is pressed and held. Releasing the button will stop movement
immediately.
3. Auto