Cooper Instruments & Systems DFR 1250 Two Channel Paperless Recorder - Manual (Page 5)

TSFM 500 DC 3 32-1101 REV 2 710
Applicable for TSTM / TSTMH test stands only
Plug one end of the RJ11 cable into this connector, and the other end into the connector on the underside of the
mechanism housing on the test stand.
6. GAUGE / Gauge Cable Connector
Plug one end of the 09-1143 cable into this connector, and the other end into a Series 5, Series BG or BGI gauge.
3.3 Connecting Power
Plug one end of the power cord into its receptacle at the rear of the controller and the other end into a wall outlet with
local earth ground (3-prong connector). Before turning on power, the following safety checks and procedures should be
performed:
1. Never operate the controller if there is any visible damage to the power cord or the test stand. The controller
is powered by 110V/220V. Any contact with this high voltage can cause serious injury or even death.
2. Ensure that the controller is kept away from water or any other electrically conductive liquids at all times.
3. Make sure the electrical outlet powering the controller has local earth ground (3-prong connector).
4. The controller should be serviced by a trained technician only. Power must be disconnected before the
controller is opened. After the above safety checks and procedures have been performed, the controller may be
powered on and is ready for operation.
4 CONTROLS LAYOUT
* Although the direction of movement differs between test stands, this user’s guide will refer to the buttons as UP and
DOWN.