Nikon F100 - Manual (Page 43)

84
Using the Speedlight
Flash
• Operation described in this section applies when the SB-80DX, SB-50DX,
SB-28/28DX, SB-27, SB-26 or SB-25 Speedlight and D- or G-type Nikkor
are attached, and Automatic Balanced Fill-Flash with TTL Multi Sensor is
used.
1 Attach the Speedlight and set the metering system.
• Set the metering system to Matrix or Center-Weighted Metering.
2 Set the exposure mode and confirm shutter speed
and aperture.
• When using Red-Eye Reduction with Slow Sync or Slow Sync, set the
exposure mode to Programmed Auto or Aperture-Priority Auto.
• Available shutter speed and aperture in each exposure mode
Exposure mode Available shutter speed Available aperture Page
Programmed Auto Automatically set
Automatically set
46
Shutter-Priority Auto 1/250-30 sec.* 48
Aperture-Priority Auto Automatically set
Desired setting
50
Manual 1/250-30 sec.*, Bulb 52
* Shutter speed changes automatically to 1/250 sec. when the shutter speed is set to
1/250 sec. or faster as soon as the attached optional Speedlight is turned on.
3 Set the flash sync mode.
• Red-Eye Reduction and Red-Eye Reduction with Slow Sync can only be
set with the SB-80DX, SB-50DX, SB-28/28DX, SB-27 and SB-26.
• With the SB-26 and SB-25, Front- and Rear-Curtain Sync settings on the
Speedlight override the setting on the camera body.
4 Set the power switch of the Speedlight to ON (or
STBY) and set the flash mode selector (MODE button
on the SB-80DX/SB-50DX/SB-28/28DX) for TTL auto
flash mode.
• Set TTL with the SB-80DX, SB-50DX, SB-28/28DX, SB-26 or SB-25 and
AUTO with SB-27.
5 Set the Speedlight’s flash sync mode selector and
check the display in the LCD panel.
• With the SB-26 or SB-25, the flash sync mode setting on the Speedlight
overrides the setting on the camera body.
• With the SB-80DX, SB-50DX, SB-28/28DX or SB-27, set the flash sync
mode on the camera body since the Speedlight has no flash sync mode
selector.
• Confirm that the indicators ˆ and ø for Automatic Balanced Fill-Flash
with TTL Multi Sensor appear in the LCD panel. If these indications do not
appear in the LCD panel, press the M button (MODE button with SB-80DX/
SB-50DX/SB-28/28DX) until ˆ and ø appear.
6 Compose picture, focus and confirm the indication in
the viewfinder.
• Lightly press the shutter release button and confirm the ready-light fi
appears in the viewfinder.
7 Confirm the flash shooting distance range and shoot.
• If the ready-light blinks approx. 3 sec. after full flash output, underexposure
may have occurred. Check the focus distance, aperture or flash shooting
distance range and shoot again.
• When using a Speedlight, make sure to read its instruction manual as well.
85
P500 (E) 02.12.27 5:48 PM Page 84
WWW.LENSINC.NET