Dell OptiPlex 760 - Manual (Page 111)

8. Connect any cables that should be attached to the card.
9. Before you close the card retention mechanism, ensure that:
l The tops of all cards and filler brackets are flush with the alignment bar.
l The notch in the top of the card or filler bracket fits around the alignment guide.
10. Secure the card(s) by closing the card retention latch and snapping it into place.
11. Replace the computer cover (see Replacing the Computer Cover ).
12. If you installed a sound card:
a. Enter system setup, select System Configuration ® Miscellaneous Devices, and change the Audio setting to Disabled. (See Entering System
Setup ).
b. Connect external audio devices to the sound card's connectors. Do not connect external audio devices to the microphone, speaker/headphone,
or line-in connectors on the back panel of the computer.
13. If you installed a network adapter card and want to turn off the integrated network adapter:
a. Enter system setup, select System Configuration ® Integrated NIC, and change the setting to Disabled. (See Entering System Setup ).
b. Connect the network cable to the network adapter card's connectors. Do not connect the network cable to the integrated network connector on
the back panel of the computer.
14. Install any drivers required for the card as described in the card documentation.
Removing a PCI Express x16 Card or DVI Card
1. Follow the procedures in Working on Your Computer .
2. Remove the computer cover (see Removing the Computer Cover ).
3. Gently lift the release tab on the card retention latch from the inside and pivot the latch open.
3 PCI Express x16 card connector
1 card fully seated 2 card not fully seated
3 bracket within slot 4 bracket caught outside of slot
CAUTION: Do not route card cables over the cards. Cables routed over the cards can prevent the computer cover from closing properly or cause
damage to the equipment.
NOTE: See the documentation for the card for information about the card's cable connections.
CAUTION: If you disable the integrated network adapter, you will not have AMT functionality.
CAUTION: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.