Bercomac Subframe & Drive Mechanism for JOHN DEERE Series X300 - Manual (Page 14)

12
ASSEMBLY
VERIFY SKID SHOE ADJUSTMENT:
LEVEL PAVED SURFACE: Adjust skid shoes to allow
3/16" to 1/4" clearance (A) between cutting edge and
surface.
UNEVEN OR GRAVEL SURFACE: Adjust skid shoes
to allow 1/2" to 5/8" clearance (A) between cutting
edge and surface.
ADJUST THE LIFT SYSTEM:
Use the adjustable link to obtain the desired lift height
(maximum 4").
NOTE: The adjustment gauge (on the tractor) for the
height of the mower deck must be in the lowest
position (position 1). See tractor owner’s manual for
more information.
VERIFY TIRE PRESSURE:
Check and adjust tractor tire pressure as follows:
Front tires: 13-14 psi
Back tires: 9-10 psi
Tire pressure must be even on both sides of tractor.
Install handle
Adjust skid shoes
VERIFY BELT ROUTING:
-Remove the belt guard.
-Lower the snowblower to the ground and let it run for
a few seconds under supervision.
-Disengage the snowblower and stop the engine.
-Check the belts to make sure they are well inserted
on the pulleys and have not flipped on their sides in
the pulleys.
-Reinstall the belt guard.
WARNING
TO PREVENT INJURIES:
It is the person who installs the drive mechanism
responsibility to make sure that when the clutch
is disengaged that all moving parts stop.
For more information, do not hesitate to contact
the technical support.
Insert the handgrip (item 1) on the handle (item 2).
Insert the handle (item 2) through the support (item 3)
as shown.
Insert the handle (item 2) in the rotation worm (item 5)
and secure with a 2.5 mm. hair pin (item 4).