HP LaserJet 1320 - Manual (Page 118)

Clearing jams
Occasionally, media becomes jammed during a print job. You are notified of a media jam by
an error in the software and the printer control panel lights. See
Status light patterns for
more information.
The following are some of the causes of media jams:
● The input trays are loaded improperly or too full. See Loading media into the input trays
for more information.
Note When you add new media, always remove all of the media from the input tray and straighten
the stack of new media. This helps prevent multiple sheets of media from feeding through
the printer at one time, reducing media jams.
● The media does not meet HP specifications. See Printer media specifications for more
information.
● The printer might need to be cleaned to remove paper dust and other particles from the
paper path. See
Cleaning the printer for instructions.
There might be loose toner in the printer after a media jam. This toner clears up after a few
sheets print.
CAUTION Media jams might result in loose toner on the page. If you get any toner on your clothes,
wash them in cold water. Hot water will permanently set the toner into the fabric.
Return to Finding the solution .
Print cartridge area
To clear a jam in the print cartridge area, perform the following steps:
CAUTION Do not use sharp objects, such as tweezers or needlenose pliers, to remove jams. Damage
caused by sharp objects will not be covered by the warranty.
1. Open the print cartridge door, and remove the print cartridge.
CAUTION To prevent damage to the print cartridge, minimize its exposure to direct light.
108 Chapter 6 Problemsolving ENWW