HP LaserJet 1300 - Manual (Page 94)

86 Chapter 6 ENWW
Gray background
Toner smear
Loose toner
Vertical repetitive defects
● Make sure that the priority input tray is in place.
● Decrease the print density setting through HP Toolbox or the
embedded web server. This decreases the amount of
background shading. See
Using the hp toolbox .
● Change the media to a lighter basis weight. See Printer media
specifications for more information.
● Check the printer’s environment. Very dry (low humidity)
conditions can increase the amount of background shading.
● Install a new HP print cartridge. See Changing the print cartridge
for instructions.
● If toner smears appear on the leading edge of the media, the
media guides might be dirty. Wipe the media guides with a dry,
lint-free cloth. See
Cleaning the printer for more information.
● Check the media type and quality.
● Try installing a new HP print cartridge. See Changing the print
cartridge for instructions.
● The fuser temperature might be too low. In your printer driver,
make sure the appropriate media type is selected.
● Clean the inside of the printer. See Cleaning the printer for
instructions.
● Check the media type and quality. See Printer media
specifications for more information.
● Try installing a new HP print cartridge. See Changing the print
cartridge for instructions.
● In your printer driver, make sure the appropriate media type is
selected.
● Plug the printer directly into an AC outlet instead of into a power
strip.
● The print cartridge might be damaged. If a repetitive mark
occurs at the same spot on the page, install a new HP print
cartridge. See
Changing the print cartridge for instructions.
● The internal parts might have toner on them. See Cleaning the
printer for more information. If the defects occur on the back of
the page, the problem will probably correct itself after a few
more printed pages.
● In your printer driver, make sure the appropriate media type is
selected.