Humboldt H-3185B CONTROLLER User Manual
Page 19
Advertising
- 19 -
© 2008 Humboldt Manufacturing
could cause fluctuations in the cycle ramp and greatly increase the overall cycle
time.
5.7 Setting Soak Temperatures
1. Continuing from section 5.6, while the green display is alternating between “rt1”
and the set ramp time value, continue pressing the Mode button
until the
green display flashes “SL1” (Figure 16). The display will alternate between
“SL1” and the soak temperature value in degrees F. As in the case of the ramp
time, this is the first of 8 soak levels available. Soak level 1 is preset to 0.
Figure 16
2. To change the soak temperature, press the up or down arrow button
until the desired temperature is achieved.
Advertising