Integra LifeSciences Sterilization Trays - Manual

INSTRUCTIONS FOR USE
Sterilization Trays
CAUTION: Federal (USA) law restricts this device to sale by or on the order of a dentist or
physician.
INDICATIONS FOR USE
Miltex Sterilization Trays are intended for the protection, organization and the delivery to the surgical field
of surgical instruments and/or other medical devices. Miltex Sterilization Trays are not designed to maintain
sterility by themselves. They are designed to facilitate the sterilization process when used in conjunction
with a wrapping material (FDA cleared sterilization wrap) or a specified filtered sterilization container
system. Wrapping materials and sterilization containers are designed to allow air removal, steam
penetration/evacuation (drying) and maintain the sterility of the internal components.
CONTRAINDICATIONS
• Miltex Sterilization Trays have not been validated for use with flexible endoscopes, or devices with
lumens or working channels longer than four inches (3mm ID). Always refer to instrument
manufacturer instructions.
WARNINGS
• Do not stack trays in autoclave chamber. Stacking of trays and overloading of the units will
adversely effect sterilization and drying effectiveness.
• Do not overload trays. Balance instrument within the trays and arrange to allow steam to come in
contact with all objects in the container.
PRECAUTIONS
• Do not load trays into sterilizer on sides or upside down with lid side on the shelf of cart. Load trays
on cart or shelf, so that the lid is always facing upward. This will allow for proper drying. Miltex
Sterilization Trays are designed to drain in this position.
• Do not use solvents, abrasives cleaners, metal brushes or abrasive pads.
• Always follow instrument manufacturer instructions if their sterilization or drying recommendations
exceed these guidelines.
• After the autoclave door is opened, all cases must be allowed to cool thoroughly. The potential for
condensation may increase if the case is not allowed to cool properly.
HOW SUPPLIED
Miltex Sterilization Trays are supplied NON-STERILE and packaged one per box.
INSTRUCTIONS FOR USE
• Both physical and chemical (detergent) processes may be necessary to clean soiled items. Chemical
(detergent) cleaners alone cannot remove all soil and debris; therefore, a careful manual cleaning of
each item with a soft sponge or cloth is essential for maximum decontamination. For difficult access
areas, a clean soft bristled brush is recommended.
• Once the items have been cleaned, they should be thoroughly rinsed with clean water to remove any
detergent or chemical residue before sterilization.
• Miltex sterilization trays can be placed in mechanical cleaning equipment.
• Always inspect for cleanliness or damage before use. Make sure all latches and handles are secure
and in working order.