Bissell 1190B - Manual (Page 11)

Operations
cleaning with Deep Reach™ tool (select models only)
1. set tool on soiled surfaces and press the
spray trigger to spray solution onto the soiled
area to be cleaned.
2. slowly move the tool back and forth over the
soiled surface, keeping the tool in contact with
the carpet.
Release spray trigger and move tool
slowly over the soiled area to suction up
water and dirt.
4. Continue to clean the area, working in small
sections, until no more dirt can be removed.
Empty dirty tank
Follow the instructions under empty dirty
tank section on page 8 of the Upright cleaning
mode section.
cleaning portable machine
1. before turning off the machine, suction up
clean water from a bowl to rinse out the interior
of the hose. Then, lift the cleaning tool and
point it upwards to drain any remaining water
into the tank.
2. Remove and rinse the tools in clean,
running water. Dry and replace in the tool
storage provided.
3. Coil flex hose around the hose wrap and
secure with latch.
4. Check suction gate and if it appears dirty,
follow steps 1-4 under Cleaning suction Gate
on page 12.
Replacing portable machine on base
1. Align the product as the graphic shows,
with the cord side on the left and hose side
on the right.
2. Push down the portable spot cleaner until
you hear it click securely into place. Test the
fit by pulling up on the carry handle to make
sure it is secure.
www.bissell.com
11
Graphic
1.
1.
3.