Bissell 1190B - Manual (Page 8)

Operations
UpRIGHt clEANING moDE
filling formula & water tank
1. Remove tank from the base of the machine by
lifting up tank carry handle.
NotE: this tank was designed with a flat
bottom so it can be easily filled.
2. Unscrew the black cap and remove bottle insert.
3. Fill tank with hand hot (60°C/140°F MAX)
tap water to the water fill line. Add 60 ml of
bissell 2X formula to the tank. Do not boil or
microwave water as it can destroy the tank.
4. Replace the bottle insert in the tank and
tighten the black cap. Replace the tank on the
deep cleaner.
carpet cleaning
1. Plug into a proper outlet and press the power
button.
2. With your foot, press the gray recline
pedal, located on the back of the unit in
between the wheels.
3. While pressing the spray trigger, make one slow
forward wet pass and another one back. caution:
Do not overwet.
4. Release the spray trigger and make one slow
forward and backward pass over the same area.
5. Repeat cleaning passes until solution being
suctioned up appears clean. Continue passes
without pressing the spray trigger until you
can’t see any more water being suctioned up.
Repeated passes will help aid in dry time.
NotE: your machine may be equipped with a
circuit breaker that will automatically shut off
the brush if a large or loose object is caught
in the brush roll. If that happens, be sure to
unplug your machine, remove the foreign
object, and then plug the machine back in to
reset the circuit breaker.
Empty dirty tank
1. When the dirty tank reaches the “FULL” line
on the tank, it is time to empty.
2. Remove dirty tank and carry to a utility sink,
toilet or outside (where you will
dispose of the dirty water).
3. To unlock the dirty tank lid, rotate handle
over the back of the tank. Remove lid and pour
out dirty water. Rinse out dirty tank to remove
any debris.
4. Replace top of tank, and rotate the handle
forward to lock in place on front of tank.
5. before replacing tank on machine, wipe debris
from red filter.
www.bissell.com
8
cAUtIoN
Take care not to run over loose objects or edges of area rugs.
Stalling the brush may result in premature belt failure.
cAUtIoN
Brush may unexpectedly restart. To reduce the risk of injury
from moving parts, unplug before cleaning or servicing.
AttENtIoN
Some Berber carpets have a tendency to fuzz with wear.
Repeated strokes in the same area with an ordinary
vacuum or deep cleaner may aggravate this condition.
1. 2.
2.
5.
3.
4.