ClearSounds ANS3000 - Manual (Page 14)

14 – ENGLISH
3. After you enter the PIN, the system will play the menu of
commands. You can then follow the commands to operate.
1 - Main Menu
2 - Play New Messages
3 - Play All Messages
5 - Turn Machine On/Off
6 - Record Outgoing Message
0 - Delete All Messages
While listening to messages, you can press 1 to replay the
current message, 2 to stop the current message, and 0 to
delete the current message.
If you record a new outgoing message, press the or
to finish. The machine will play the outgoing message you
recorded.
Reminder: Your answering machine must be turned ON in
order to use remote access. Stop the message playback
before hanging up the remote access call.
█
Remote Access Code
The four-digit default PIN is ‘0000’. To change the PIN:
1. Press and hold the Repeat key to enter the set-up mode.
2. Press the Vol+ or Vol- key to adjust the first digit. You will
see the digit display on the LED. Press and hold the Repeat
key to confirm and then enter the second digit by pressing
the Vol+ or Vol- key.
3. Press and hold the Repeat key to confirm and then enter
the third digit by pressing the Vol+ or Vol- key.
4. Press and hold the Repeat key to confirm and then enter
the fourth digit by pressing the Vol+ or Vol- key.
5. Press and hold the Repeat key until you hear a long been
and the LED will return to idle mode.