Bissell 48F3ER - Manual (Page 14)

w w w . b i s s e l l . c o m
M
aintenance and care
14
Belt removal and replacement
1. turn off the machine and unplug it from
the outlet.
2. Remove the dirty and clean water/solu-
tion tanks from the base of the machine.
3. While standing behind the unit, lay the
unit on its’ side (cord side up)
4. looking at the bottom of unit, find
the back center of the brush carriage
where the carriage latch is located. It
is between the brush assembly and the
front wheels.
5. pull brush carriage towards you with
one hand until it stops, then pinch the
carriage latch with other hand while
pulling the carriage towards you. the
carriage should swing out to access belt
cover.
6. Remove three screws from cover. lift and
remove to access brush carriage.
7. turn the belt inward towards the large
pulley while lifting out.
8. place new belt over small pulley first and
then slip the belt over the large pulley.
9. Replace the brush carriage and screws.
10. push brush carriage back into place
making sure the carriage latch locks
back into place.
4.
6B. 6A.
8.
10.
3.
5.
7.
9.
WARNING:
to reduce the risk of fire, electric
shock, or injury,turn power
off and disconnect plug from
electrical outlet before performing
maintenance or troubleshooting.