Bissell 48F3ER - Manual (Page 7)

w w w . b i s s e l l . c o m
7
O
perations
Carpet cleaning
1. Remove dirty water tank. pull dirty water
tank handle to upright position and lift up
to remove dirty water tank.
2. lift clean water/solution tank from the base
of machine.
A. unscrew cap on top of the clean water
tank. fill tank to FILL line with clean,
hand hot tap water.
B. Measure bIssell formula using cap
on tank. fill cap to line twice for each
full tank of water. Always use genuine
bIssell formulas to maximize cleaning
and for the safety of your machine
C. screw cap back onto clean
water/solution tank and place tank onto
base of the machine.
3. Replace dirty water tank securely on top
of the clean water/solution tank and push
handle back to lock into place.
4. plug into a proper outlet and turn the
power switch to the oN ( I ) position.
5. detent handle by pushing down on the
green lever on the back of the machine
while pulling back.
6. Cleaning strokes. While pressing the
trigger, make one slow forward wet pass
and another back. let the formula and
dirtlifter powerbrush do the work for you.
Note: Your machine is equipped
with a circuit breaker that will
automatically shut off the brush if a
large or loose object is caught in the
brush roll. If that happens, be sure
to unplug your machine, remove the
foreign object and then plug machine
in to reset the circuit breaker.
Keep plenty of genuine BISSELL 2X
formula on hand so you can clean
whenever it fits your schedule. Always
use genuine BISSELL deep cleaning
formulas. Non-BISSELL cleaning
solutions may harm the machine and
void the warranty.
3.
1.
2C.
3.
5.
1.
2. 2A.