Peration – Bissell Spot Bot 88D6 series User Manual

Page 10

Advertising
background image

Manual/hose cleaning

1.

Remove the hose from the unit by

depressing the release button.

2.

Remove the Tough Stain Brush from the

back of the unit by depressing the release

button. Attach the Tough Stain Brush onto

the grip of the flex hose.

3.

Select the manual/hose button on the

control panel to start the SpotBot.

NOTE: In manual mode, the Spotbot will not

turn on until the hose is removed from the

unit. If it is not removed within 30 seconds of

pushing the start button, the unit will shut off.

4.

If your unit has a built in heater (not

standard on all models) press the heater

button to turn on the heat feature. Begin

cleaning by holding the tool no more than six

inches above the soiled surface. Depress the

spray trigger for about five seconds to apply

the cleaning solution to the soiled area then

release the spray trigger. Be careful not to

over wet.

5.

Using the brush on the tool, gently scrub the

soiled area for about 30 seconds or until the

soiled area appears to be clean.

6.

To suction up the dirt and cleaning solution,

position the suction nozzle over the cleaned

area, apply downward pressure on the tool,

and pull nozzle toward you. You should see the

dirty water pass through the nozzle. Continue

until no more water can be removed. Normally,

this step will require no more than one minute

of back and forth passes.

NOTE: In manual mode, the Spotbot is

equipped with a safety feature which will

shut the unit off after 30 minutes. Press

start to resume cleaning.

7.

If the stain is still visible, repeat steps 4-6

as necessary.

8.

When the cleaning is complete, lightly drag

the suction nozzle across the stain for about

two minutes to further aid in drying the

cleaned area.

9.

Press the manual/hose button to turn off

the SpotBot.

10

w w w . b i s s e l l . c o m

O

peration

Tip:

Check upholstery stuffing

before cleaning. Colored

stuffing may bleed through

the fabric when it becomes

wet.

Tip:

one of the effective stain

removing ingredients in oxy

GEN2 is hydrogen Peroxide.

Certain people may be

affected by the formula

when it comes into contact

with their skin; it may turn

the skin white and/or cause

tingling. Washing your hands

after use and applying hand

lotion will remove any

possible white discoloration.

1

2a

2b

Advertising