Bissell 48W4 - Manual (Page 5)

your deep cleaner assembles quickly and
easily. the only tool you will need for
assembly is a phillips head screwdriver.
1. locate the screw pack, which is taped
to the upper handle.
2. slide the upper body onto the lower
body, taking care not to leave a gap
between the upper and lower body.
3. firmly holding the upper body, screw the
2 screws into the holes marked with arrows.
tip: if you are having difficulty tightening the
screws, remove, re-insert, and tighten again.
4. After tightening the screws, ensure proper fit
between the upper and lower body by trying
to separate the two. if assembled properly,
there should be no gap. if a gap appears
between the two (see picture at right), continue
to tighten the screws until no gap is present.
5. slide upper handle into upper body by
aligning the pin and sliding into place.
note: be sure to secure upper
handle before lifting. Rotate handle
lock clockwise to secure.
6. Place solution tank on back of unit.
7. Wrap power cord.
assembly is now complete.
special features
scotchgard™ protector
Carpet protection applied at the mill typically
wears down over time from heavy foot traffic and
everyday cleaning, including deep cleaning. To
help restore this important protection, only BISSELL
offers cleaning formulas with Scotchgard protector.
This offers extra protection against dirt and tough
stains to keep your carpets looking good longer.
Microban® antibacterial
product protection
Microban antibacterial product protection is
built into key components to help prevent
the growth of harmful common household
bacteria. It helps to keep the unit fresher and
cleaner between uses.
w w w. b i s s e l l . c o m
A
ssembly
5
O
perations
2.
5. 6.
3.
pin
coRRect incoRRect
4.