Bissell 48W4 - Manual (Page 8)

w w w. b i s s e l l . c o m
O
perations
M
aintenance and care
8
cleaning after use
1. unplug the unit.
2. remove and rinse collection tank thoroughly.
3. remove tank vent & foam filter (located
on top of the collection tank) and rinse.
4. Clean nozzle window by lifting latch
and removing nozzle from machine.
rinse under running water.
5. for 39Q6 series models, pop out
CrossAction Brush by pushing the tabs
away from each other and pushing
down. once the brush pops out, rinse
and replace by snapping the tabs back
into place.
6. When finished, replace nozzle and
secure with latch.
note: for best results, it is
recommended that the nozzle
is cleaned after each use.
7. remove lint and hair from red gasket in
base of unit. (do not remove gasket)
8. replace the collection tank on the base
of the machine and secure with latches.
Machine storage
for best results, a few simple steps
can assure your machine is well
maintained after your cleaning
is complete.
1. Wrap power cord around Quick release
Cord Wrap™ on side of the machine.
2. Wipe all surfaces with a soft cloth. store
cleaner upright in a protected, dry area.
note: you may have cleaning
solution remaining in the solution
tank. you may store your machine
this way for the next cleaning
task, but never keep dirty water
in the collection tank.
caution:
Do not store unit where
freezing may occur.
Damage to internal
components may result.
WaRning:
To reduce the risk of injury from
moving parts and/or electrical
shock, turn power switch OFF
and disconnect plug from
electrical outlet before
performing maintenance or
troubleshooting checks.
6. 7.
3. 4.
5.