Bissell 3278 - Manual (Page 7)

filling the 2-in-1 water tank
1. Remove tank from base of machine by lifting
tank carry handle. Carry like a bucket to the sink.
2. Pull upward on bottom edge of latch in the
back of tank to unhook and remove lid.
3. Pull up on bladder fill cover that says
“Fill Here”. Fill the bladder with hand hot
(60°C/140°F MAX) tap water. Do not boil or
microwave water as it can destroy the bladder.
4. Using measuring cup provided, fill to indicated
fill line on measuring cup and pour in to bladder.
NotE: Always use genuine bISSEll 2X
formulas to maximize cleaning and for the
safety of your machine.
5. Replace tank lid by seating front edge of tank
before back, then lock latch in place.
NotE: Remember to secure lid and test to
make sure it is secure before picking up tank.
6. Place tank into machine base, seating
firmly in place.
carpet cleaning
1. Plug into a proper outlet. set ReadyTools dial
to Floor Cleaning setting. Turn power on by
pressing red power pedal
on back of machine
with your foot.
2. With your foot, press gray recline pedal located
on back of machine next to red power pedal.
3. While pressing spray trigger, make one slow
forward wet pass and another back. caution:
do not overwet.
4. Release spray trigger and make one slow
forward and backward pass over same area.
5. Repeat cleaning passes until solution being
suctioned up appears clean. Continue passes
without pressing spray trigger until you can’t
see any more water being suctioned up.
Repeated passes will help aid in dry time.
NotE: you may notice hair and debris deposits
on the carpet or in the tank that were loosened
by the cleaning action. this debris should be
picked up and thrown away.
Operations
www.bissell.com
AttENtIoN
Some Berber carpets have a tendency to fuzz with wear.
Repeated strokes in the same area with an ordinary
vacuum or deep cleaner may aggravate this condition.
7
1. 2.
3.
6.
cAUtIoN
Take care not to run over loose objects or edges of
area rugs. Stalling the brush may result in premature
belt failure.
WARNING
To reduce the risk of fire and electric shock due to internal
component damage, use only BISSELL cleaning fluids
intended for use with the deep cleaner. Non-BISSELL
cleaning solutions may harm the machine and void
the guarantee.
Power Pedal Recline Pedal
5.