Bissell 3278 - Manual (Page 9)

3. set ReadyTools dial to TOOls setting. This
will allow spray and suction from hose.
4. Attach cleaning tool of your choice to end
of hose.
NotE: If your deep cleaner came with a Deep
Reach tool, do not follow the cleaning tool
instructions below. Instead, follow the “cleaning
with Deep Reach tool” instructions in the next
section.
5. Hold tool approximately 2.5 cm above soiled
surface. Press spray trigger to apply cleaning
solution to soiled area. Using brush on tool,
gently scrub area to be cleaned. Release spray
trigger, apply downward pressure on tool
and pull it toward you to suction up dirt and
cleaning solution. Continue until no more dirt
can be removed. Caution: Do Not Overwet.
6. When finished cleaning, remove and rinse
tool(s) in clean, running water.
7. it is recommended that you suction clean
water from the tap to rinse out the hose. be
careful not to over-fill your tank.
8. before wrapping hose onto rack, lift end
of hose and stretch out to ensure all water is
cleared from hose.
9. Wrap hose around rack.
10. empty 2-in-1 water tank and rinse out,
following instructions on page 8.
11. if ReadyTools dial becomes difficult to turn, the
diverter assembly that holds dial may need to be
cleaned. To clean, first remove nozzle and locate
screw that holds diverter assembly in place. With a
Phillips screwdriver, remove the screw and set aside.
12. Remove diverter assembly; hold under
running water making sure water flows through
and around dial. Turn dial about 10 times
clockwise and 10 more times counter clockwise.
This should free up any debris.
13. Wipe diverter assembly with a soft cloth
and replace back on machine. Replace nozzle.
14. Return ReadyTools dial to FlOOR
CleANiNG setting.
cleaning with Deep Reach™ tool
1. set tool on soiled surfaces and press spray
trigger to spray solution onto soiled area to
be cleaned.
2. slowly move tool back and forth over soiled
surface, keeping tool in contact with carpet.
3. Release spray trigger and move tool slowly
over soiled area to suction up water and dirt.
4. Continue to clean the area, working in small
sections, until no more dirt can be removed.
Operation
www.bissell.com
9
3.
11.
8.
12.
1.
3.