Bissell 1273e - Manual (Page 5)

w w w. b i s s e l l . c o m
A
ssembly
1. Connect hose to vacuum by inserting
hose connector on the end of the hose
into the suction inlet. make sure the
hose is positioned so the tabs on the
hose connector line up with the notches
on the suction inlet. once inserted into
the suction inlet, turn to lock into place.
2. Attach extension wands section together
by inserting into one another and
twisting slightly to tighten.
3. Connect hose handle to the end of
the extension wand and twist slightly
to tighten.
4. Connect floor nozzle to the end of
the extension wand and twist slightly
to tighten.
5. once assembled, you can store your
vacuum by inserting the storage clip
(located on the back of the floor nozzle)
into the storage slot on the rear of
the vacuum.
Power cord
The power cord is located at the rear of the
vacuum. Gently pull out the power cord,
watching for the yellow line. stop pulling the
power cord once the yellow line is visible.
There is also a red line, which indicates the
end of the usable cord. Do not pull the
power cord out beyond the red line.
automatic cord rewind
Your vacuum is equipped with an automatic
cord rewind. When cleaning is finished, press
the power button oFF and grasp the plug to
disconnect from the electrical outlet. hold the
plug and press the automatic cord rewind
button to rewind the cord automatically.
Power button
Turn the power oN or oFF by pressing lightly
downward on the power button ( ).
5
1.
5.
4.
3.
2.
WaRning:
Plastic film can be dangerous. To
avoid danger of suffocation, keep
away from babies and children.
suction Inlet
O
perations
Automatic Cord
Rewind Button
colours may vary
from models shown
caution:
Be careful to avoid injury as cord
retracts very quickly.
caution:
Before using your vacuum,
make sure that the dirt cup and
all filters are in place. Do not
operate your vacuum without
the dirt cup and filters.
Power
Button