Bissell 1273e - Manual (Page 8)

w w w. b i s s e l l . c o m
M
aintenance and care
8
7. Insert the dirt cup filter assembly back into
the dirt cup by lining up the tabs on the
top of the dirt cup filter assembly with the
notches inside the top of the dirt cup and
turning the handle on the bottom of the
dirt cup filter assembly clockwise to lock
into place.
Replacing the post-motor filter
The post-motor filter assists in the filtration
process to return cleaner air to the room.
Use only BIssell replacement filters in
your vacuum.
1. Unplug the vacuum from electrical outlet.
2. Remove the filter door (located on the back
of the vacuum) by pushing down on the tab
and pulling out and away from the vacuum.
3. The post-motor filter can be hand washed
in cold water with a mild detergent. Rinse
well and air dry thoroughly before
placing back into the vacuum.
4. Replace the filter door by placing the tabs
on the bottom of the filter door into the
notches on the bottom of the post-motor filter
compartment and pushing the tab forward
back into the vacuum to lock into place.
cleaning the dirt cup filter continued
notice:
This product is intended for household
use only and not for commercial or
industrial use. Vacuuming of dust
from products like plaster, concrete
or ashes will damage the motor and
void the warranty.
Tip:
For maximum cleaning performance,
check the filters often and clean or
replace if necessary.
WaRning:
Do not operate cleaner with
damp or wet filters or without
all filters in place.
2.