Bissell 2177 - Manual (Page 13)

Troubleshooting
WaRnInG
To reduce the risk of electric shock, turn power switch off
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
problem possible causes Remedies
Vacuum
cleaner won’t
turn on
Power cord not plugged in Check electrical plug
blown fuse/tripped breaker Check/replace fuse or reset breaker
no power
at rotating
floor brush
Pod is not securely seated Remove pod and replace, making
sure that it "clicks" into place
brush switch turned to "OFF" Make sure brush switch is in "ON" position
Vacuum is in upright position Recline vacuum to operate brush
Vacuum
cleaner won’t
pick up dirt
Hose not attached to suction
opening Grasp quick reach handle and firmly push
hose wand onto the suction opening
Crack or hole in hose Check hose and replace if needed
broken or worn drive belt Replace drive belt, see pages 10, 11
Rotating floor brush bristles worn Replace brush
Rotating floor brush jammed Remove brush and clean debris from
brush ends
Clog in vacuum Follow instructions on page 12 for
clearing clogs
Dirt container full empty dirt container
Dirt container or secondary
cyclone not installed properly Position correctly and lock in place
Filters are dirty Check and clean pre-motor and
post-motor filters, see page 9
Visible dirt
escaping
from cleaner
Dirt container full empty dirt container
Filters or secondary cyclone
missing or installed incorrectly Check secondary cyclone, pre-motor and
post-motor filters for correct installation
Dirt container installed incorrectly Pull out and re-insert dirt container
correctly
www.bissell.com
800.237.7691
Other maintenance or service not included in the manual should be
performed by an authorized service representative.
Thank you for selecting a bissell product.
for any questions or concerns, bISSEll is happy to
be of service. contact us directly at 1-800-237-7691.
please do
not return
this product
to the store.
13