Bissell 7364e - Manual (Page 6)

10 Screws
w w w. b i s s e l l . c o m
M
aintenance and care
6
using your pet Hair eraser sweeper
1. Make sure that the Pet Hair Eraser
Sweeper is in the “OFF” position.
2. With the sweeper facing toward you,
lift the dirt cup out by lifting up on the
scoop handle.
3. Carry the dirt cup to a waste container.
Using one finger push down on either of
the corner tabs on the bottom corners of
the dirt bin. This dirt bin is spring loaded
and will open allowing dirt to fall into
waste container.
4. Close bottom of dirt cup. Replace the dirt
cup by gently pressing it into the foot of
the sweeper. Make sure that it fits secure-
ly.
5. Clean exterior surfaces with a soft cloth
dampened with water only. Do not use
a strong detergent or other cleaner – this
may damage the finish. Always unplug the
Pet Hair Eraser Sweeper from the electrical
outlet before cleaning the surface.
battery Removal and disposal
note: it is required that the battery
be removed from the pet Hair eraser
sweeper before it is disposed of.
1. Important: Unplug charger.
2. Remove handle and dirt cup.
3. Remove (10) Phillips head screws on
the bottom cover as shown in picture.
4. Separate top and bottom cover.
5. Remove wire connectors from the
battery pack.
6. Keep battery pack togaether – DO NOT
separate individual batteries. For specific
disposal instructions, please contact your
local authorities for requirements and
regulations on safe disposal or recycling
facilities in your area.
7. Discard remainder of product.
2.
3.
WaRning:
This product contains a recharge-
able nickel metal hydride
battery (sometimes referred to
as a “NiMh” battery) pack. The
average life of a NiMh battery
is 5 to 7 years, depending on
frequency of use. proper removal
and disposal of NiMh batteries
is required.
WaRning:
To reduce the risk of electric
shock, turn power switch oFF
and disconnect charger from
electrical outlet before performing
maintenance or troubleshooting.