Bissell 9151e - Manual (Page 4)

w w w. b i s s e l l . c o m
4
P
roduct view
Handle
Assembly
Metal Extension Handle
Power Switch
Charging Port
DC Adapter
Charging
Indicator Light
Handle Clip
Dirt Cup
Rotating Brush
Dual Edge
Cleaning Brushes
Handle Grip
A
ssembly
the superb sweep turbo requires very
little assembly. Remove it from the box
and check it against the illustration to
familiarize yourself with the components
listed. the exploded view drawing with
part names will also be helpful if you
should need to order a part at a later time.
1. Assemble the handle by screwing together two
pieces of the metal extension handle. Place
the colored handle grip on top of the metal
extension assembly and twist clockwise until
secure. Screw the handle clip into the bottom
of the metal extension handle assembly.
2. Place bottom of handle clip into the
opening at the top of the Superb Sweep
Turbo. Push firmly until the button at the
bottom “clicks” into place in the opening.
3. The Superb Sweep Turbo must be fully
charged before using. To charge the unit,
plug the DC adapter into a standard
electrical outlet (220-240 V – 50/60 Hz);
plug the opposite end into the charging port
on the back side of your Superb Sweep
Turbo. The charging indicator light will
illuminate when properly connected and will
not turn off when fully charged. The Superb
Sweep Turbo is now charging.
note: the Power switch must be in
the off position when charging.
Charging cord
with DC adapter
plug
Plug into charging
port on the motor
side of the Superb
Sweep Turbo.
WaRning:
Electric/electronic appliances
should not be subjected to
extreme temperatures or
high humidity. Do not store
the Superb Sweep Turbo in
bathing areas or close to stoves,
furnaces or radiators.