EcoPure MW_MW15_450217 - Manual (Page 20)

ELECTRONIC DEMAND TIMER FEATURES, AND SERVICE, continued
service: MANUAL INITIATED ELECTRONICS DIAGNOSTIC . . . . . . . . . . . . . . . . . . . . . . . . . .
1. To enter diagnostics, press and hold the SELECT
button until (000 - -) shows in the display. Use the RECHARGE button to manually advance
the valve into each cycle and check correct switch
operation.
CORRECT VALVE CYCLE STATUS
SWITCH
DISPLAYS
- - Valve in service, fill, brining,
backwash or fast rinse
position.
- P Valve rotating from one
position to another.
(C) While in this diagnostic screen, the following
information is available and may be beneficial for
various reasons. This information is retained by the
computer from the first time electrical power is
applied to the face plate.
(A)The first 3 digits indicate water meter operation
as follows:
#
000 (steady) = soft water not in use…no flow
through the meter.
- OPEN A NEARBY SOFT WATER FAUCET -
#
000 to 199 (continual) = repeats display for each
gallon of water passing through the meter.
If you don't get a reading in the display, with faucet
open, pull the sensor from the valve outlet port.
Pass a small magnet back and forth in front of the
sensor. You should get a reading in the display. If
you get a reading, unhook the in and out plumbing
and check the turbine for binding.
(B) The letter (P) and dash(es) indicate POSITION
switch operation. The letter appearing means the
switch is closed; the dash means the switch is open.
…Press the UP button to
display the number of days
this face plate has had elec-
trical power applied.
…Press the DOWN button
to display the number of
regenerations initiated by
this face plate since the
model code number was
entered.
2. Press the SELECT button
and hold in 3 seconds until a
model code appears in the
display.
For correct softener operation, the SR number
must be SR14.
To reset the code, press the UP or DOWN button
until the correst number shows.
3. Press SELECT to return the present time display.
If the code was changed, make ALL the timer set-
tings, pages 10 and 11.
20
NOTE: If the face plate is left in a diagnostic display (or a flashing dis-
play when setting times or hardness), present time automatically returns
if a button is not pressed within 4 minutes.