Installation, Step 1. turn off water supply, Step 2. move the unit into place – EcoPure MW_MW30_7301415D User Manual
Page 12
Advertising
12
Miracle Water Installation & Operation Manual
Installation
Step 1. Turn Off Water Supply
1. Close the main water supply valve, near the well pump or water meter.
2. Shut off the electric or fuel supply to the water heater.
3. Open all faucets to drain all water from the house pipes.
Step 2. Move the Unit into Place
Move the unit into installation position. Set it on a solid, smooth and level surface. If needed, place
the unit on a section of plywood, a minimum of 3/4” thick. Then, shim under the plywood to level
the unit, see Figure7.
CAUTION: DO NOT PLACE SHIMS DIRECTLY UNDER THE SALT STORAGE TANK. The
weight of the tank, when full of water and salt, may cause the tank to fracture at
the shim.
Advertising