Edge Lighting Cody LED Picture Light - Manual (Page 2)

2
MOUNTING BRACKET
C
4
5
ANCHOR
WALL
3: Hold the mounting bracket against the wall where Cody 12"
will be mounted. Level the mounting bracket and mark the
bracket holes on the wall.
4: Tap the anchors onto the marked points into the wall up to
the threaded portion with a hammer.
5: Screw the threaded portion of the anchors in with the a
Phillips screwdriver.
NOTE: The Cody 12" plug-in comes with 9' of cord and
plug-in power supply. Make sure there is a power outlet
near to where Cody 12" will be mounted
3
3
D
#8 SCREW
MOUNTING BRACKET
6: Line up the mounting bracket holes with the anchors and
secure the fixture to the anchors with the four #8 screws
provided.
ANCHOR
6
6
ARM
2MM ALLEN WRENCH
M4 SET SCREW 7
7: To adjust the height, loosen the four M4 set screw on the
mounting brackets with the provided 2mm Allen wrench.
Adjust the Cody to the desired height by sliding it up or
down. Tighten the four M4 set screws with the 2mm Allen
wrench.
MOUNTING BRACKET
E
7