Deactivating memory from the remote control, Car finder, Sounding a panic alarm – FORD 2015 Explorer User Manual

Page 67: Remote start (if equipped), 66 keys and remote control

Advertising
background image

Deactivating Memory from the Remote Control

1. Press and hold the desired memory button for five seconds. You will
hear a tone in about two seconds. Continue to hold until you hear a
second tone.

2. Press the unlock button on the remote control.

3. Repeat this procedure for each additional transmitter if desired.

Car Finder

Press the button twice within three seconds. The horn will
sound and the turn signals will flash. We recommend you use
this method to locate your vehicle, rather than using the panic

alarm.

Sounding a Panic Alarm

Press the button to activate the alarm. Press the button again
or switch the ignition on to deactivate.

Note: The panic alarm will only operate when the ignition is off.

Remote Start (If Equipped)

WARNING: To avoid exhaust fumes, do not use remote start if
your vehicle is parked indoors or areas that are not well

ventilated.

Note: Do not use remote start if your vehicle is low on fuel.

The remote start button is on the transmitter.

This feature allows you to start your vehicle from outside your vehicle.
The transmitter has an extended operating range.

Vehicles with automatic climate control can be configured to operate
when the vehicle is remote started. See the Climate Control chapter for
more information. A manual climate control system will run at the setting
it was set to when your vehicle was last turned off.

Many states and provinces have restrictions for the use of remote start.
Check your local and state or provincial laws for specific requirements
regarding remote start systems.

66

Keys and Remote Control

2015 Explorer (exp)
Owners Guide gf, 2nd Printing, September 2014
USA
(fus)

Advertising