Wheels and tires – FORD 2015 Fusion User Manual

Page 278

Advertising
background image

What to do when a Tire Is

Punctured

A tire puncture within the tire tread area
can be repaired in two stages with the kit.

In the first stage, the tire will be
reinflated with a sealing compound
and air. After the tire has been
reinflated, you will need to drive the
vehicle a short distance 4 mi (6 km) to
distribute the sealant in the tire.

In the second stage, you will need to
check the tire pressure and adjust, if
necessary, to the vehicle tire inflation
pressure.

First Stage: Reinflating the Tire
with Sealing Compound and Air

WARNINGS

Do not stand directly over the kit
while inflating the tire. If you notice
any unusual bulges or deformations

in the tire sidewall during inflation, stop
and call roadside assistance.

If the tire does not inflate to the
recommended tire pressure within
15 minutes, stop and call roadside

assistance.

Preparation: Park the vehicle in a safe, level
and secure area, away from moving traffic.
Turn the hazard lights on. Apply the parking
brake and turn the engine off. Inspect the
flat tire for visible damage.

Sealant compound contains latex. To
avoid any allergic reactions, use the
non-latex gloves located in the accessory
box on the underside of the kit housing.

Do not remove any foreign object that has
pierced the tire. If a puncture is located in
the tire sidewall, stop and call roadside
assistance.

1.

Remove the valve cap from the tire
valve.

2. Unwrap the clear tube from the

compressor housing.

3. Remove the tube cap and fasten the

metal connector of the tube to the tire
valve, turning clockwise. Make sure the
connection is tightly fastened.

E144619

4. Plug the power cable into the 12-volt

power point in the vehicle.

5. Remove the warning sticker found on

the canister and place it on the top of
the instrument panel or the center of
the dash.

6. Start the vehicle only if the vehicle is

outdoors or in a well-ventilated area.

E144924

7.

Push and turn dial (A)
counterclockwise to the sealant
position. Turn on the kit by pressing the
on/off button (B).

275

Fusion/Mondeo (CC7), enUSA

Wheels and Tires

Advertising