FORD 2014 Expedition v.1 - Manual (Page 111)

• OIL LIFE: This displays the remaining oil life. An oil change is
required whenever indicated by the message center and according to
the recommended maintenance schedule. USE ONLY
RECOMMENDED ENGINE OILS.
To reset the oil monitoring system to 100% after each oil change,
perform the following:
1. Press and release the SETUP button to display “OIL LIFE XXX%
HOLD RESET = NEW”.
2. Press and hold the RESET button for two seconds and release to reset
the oil life to 100%.
Note: To change oil life 100% value (if equipped with this feature) to
another value, proceed to Step 3.
3. Once “OIL LIFE SET TO XXX%” is displayed, release and press the
RESET button to change the Oil Life Start Value. Each release and press
will reduce the value by 10%.
• UNITS ENG / METRIC: Displays the current units in English or Metric.
• AUTOLAMP: This feature keeps your headlights on for up to three
minutes after the ignition is switched off.
• AUTOLOCK: This feature automatically locks all vehicle doors when
the vehicle is shifted into any gear, putting the vehicle in motion.
• AUTOUNLOCK: This feature automatically unlocks all vehicle doors
when the driver’s door is opened within 10 minutes of the ignition
being turned off.
• TRAILER SWAY (if equipped): This feature uses the electronic
stability control to mitigate trailer sway.
• TBC MODE (if equipped): Allows you to choose the trailer brake
mode.
• CREATE MYKEY / MYKEY SETUP / CLEAR MYKEY: For more
information refer to the MyKey® chapter.
• LANGUAGE = ENGLISH / SPANISH / FRENCH: Allows you to choose
which language the message center will display in.
Waiting four seconds or pressing the SELECT/RESET stem cycles the
message center through each of the language choices.
Press the SELECT/RESET stem to set the language choice when the
language you want appears.
110 Information Displays
2014 Expedition (exd)
Owners Guide gf, 1st Printing, June 2013
USA (fus)