FORD 2014 Explorer v.3 - Manual (Page 68)

Programming Memory to the Remote Control
1. Turn the ignition on.
2. Move the memory features
to the desired positions using the
associated controls.
3. Press and hold button 1 for five
seconds. A tone will sound in about
two seconds. Continue to hold until
you hear a second tone.
4. Press the lock button on the
remote control within three
seconds.
5. Repeat this procedure for another memory button and transmitter if
desired.
Deactivating Memory from the Remote Control
1. Press and hold the desired memory button for five seconds. You will
hear a tone in about two seconds. Continue to hold until you hear a
second tone.
2. Press the unlock button on the remote control.
3. Repeat this procedure for each additional transmitter if desired.
Car Finder
Press the button twice within three seconds. The horn will sound
and the turn signals will flash. We recommend you use this method
to locate your vehicle, rather than using the panic alarm.
Sounding a Panic Alarm
Press the button to activate the alarm. Press the button again
or switch the ignition on to deactivate.
Note: The panic alarm will only operate when the ignition is off.
Keys and Remote Control 67
2014 Explorer (exp)
Owners Guide gf, 3rd Printing, September 2013
USA (fus)