Load carrying – FORD 2014 F-550 v.1 User Manual

Page 186

Advertising
background image

Opening the Step

Note: Make sure to close and fully latch the
step before moving your vehicle. Never drive
with the step or grab handle open.

1.

Lower the tailgate.

2. Pull the yellow lever on the grab handle

to the unlock position.

E163093

3. Raise the handle upright until you feel

it latch and see the lever in the lock
position. You only need to use the lever
when releasing the grab handle.

E163094

4. Rotate the center molding to unlatch

the step. Pull it toward you to extend
it.

5. Open the step panel to widen the step.
Note: Do not tow with the step or grab
handle.

Replace the slip resistance tape or grab
handle molding if it appears worn or
damaged.

Closing the Step

1.

Close the step panel then lift and fully
close the step into the tailgate.

2. Move the yellow lever on the grab

handle to the unlock position and lower
the handle.

Bed Extender

(If Equipped)

Note: Do not use the bed extender when
driving off road.

Note: Make sure to engage the locking pins
and knobs fully before driving your vehicle.

Note: Make sure to secure all cargo.

Note: Do not exceed 150 pounds (68
kilograms) on the tailgate when your vehicle
is moving.

Note: Do not keep the bed extender in the
tailgate mode when you are not using it for
restraining cargo. Always keep the bed
extender in the grocery mode or the stowed
position with the tailgate closed.

Tailgate Mode

E163095

1.

Pull the locking pin toward the center
of your vehicle.

183

Super Duty (TFA)

Load Carrying

Advertising
This manual is related to the following products: