Wheels and tires – FORD 2014 F-550 v.3 User Manual

Page 267

Advertising
background image

Note: Do not reduce tire pressure

to change the ride characteristics

of the vehicle. If you do not

maintain the inflation pressure at

the levels specified by Ford, your
vehicle may experience a condition
known as shimmy. Shimmy is a
severe vibration and oscillation in
the steering wheel after the vehicle
travels over a bump or dip in the
road that does not dampen out by
itself. Shimmy may result from
significant under-inflation of the
tires, improper tires (load range,
size, or type), or vehicle
modifications such as lift-kits. In

the event that your vehicle

experiences shimmy, you should

slowly reduce speed by either lifting
off the accelerator pedal or lightly

applying the brakes. The shimmy

will cease as the vehicle speed

decreases.
Maximum Inflation Pressure is

the tire manufacturer's maximum

permissible pressure and the
pressure at which the maximum

load can be carried by the tire. This

pressure is normally higher than

the manufacturer’s recommended

cold inflation pressure which can

be found on the Safety
Compliance Certification Label

(affixed to either the door hinge
pillar, door-latch post, or the door

edge that meets the door-latch
post, next to the driver's seating
position), or Tire Label located on

the B-pillar or the edge of the

driver's door. The cold inflation

pressure should never be set lower

than the recommended pressure
on the Safety Compliance
Certification Label or Tire Label.

When weather temperature
changes occur, tire inflation
pressures also change. A 10°F
(6°C) temperature drop can
cause a corresponding drop of 1
psi (7 kPa) in inflation pressure.
Check your tire pressures
frequently and adjust them to the
proper pressure which can be
found on the Safety Compliance

Certification Label or Tire Label.
To check the pressure in your
tire(s):
1. Make sure the tires are cool,

meaning they are not hot from

driving even a mile.
Note: If you are checking tire

pressure when the tire is hot, (for

example, driven more than 1 mile

[1.6 kilometers]), never bleed or

reduce air pressure. The tires are
hot from driving and it is normal for

pressures to increase above
recommended cold pressures. A

hot tire at or below recommended

cold inflation pressure could be

significantly under-inflated.

264

Super Duty (TFA)

Wheels and Tires

Advertising
This manual is related to the following products: